Programmable Optical Pulse Shaper 10 NS or >100 NS Duration

POPS-10 Specifications

  • Rise/fall: ~200ps
  • Load: 50 Ohms
  • Duration: 12 ns
  • Sample rate: ~10 Gs/s
  • Number of samples: 112 (224 bytes)
  • Trigger : 5V into ~ 2kohms
  • PRF: 1 kHz
  • Output amplitude: ~8 V
  • Proportional monitor: 0.8 V into 50ohms, divided from output
  • Interface: RS232, 9600 baud
  • Power: 100-240 V ac, >30 VA
  • AC power: Rocker Switch
  • Trigger input : BNC
  • Modulator input & output: FC-APC
  • Proportional monitor: SMA
  • Bias monitor: DMM test point
  • LEDs: See full manual for controls
  • RS232 Serial: 9 pin DSub
  • Remote Link (Aux) : 15 pin DSub (optional)
  • Dither inhibit input: BNC
  • Proportional monitor: SMA
  • Bias Contoller: Built into POPS10

POPS-100 Specifications

  • Rise/fall : ~200 ps
  • Load : 50 ohms
  • Duration : 100 ns
  • Sample rate : 8 Gs/s
  • Number of samples : 800 (1600 bytes)
  • Trigger: 5 V into 50 ohm
  • PRF : 50 kHz
  • Output amplitude : ~6 V
  • Proportional monitor: 0.35 V into 50 ohms, divided down from the output by factor of 20
  • Interface : RS232, 9600 baud
  • Power : 100-240V ac, >30 VA
  • AC power : Rocker switch (front panel), IEC AC inlet (rear panel), fused 110/240 Volt a.c. power- inlet and rocker-switch, fuse fitted is a 250 V 3.15 A Type T, ceramic anti-surge
  • Trigger input: BNC, 5 V into 50 ohm
  • Modulator input & output: FC-APC Proportional monitor : SMA
  • Bias monitor : DMM test point LEDs: See full manual for controls
  • RS232: 9 pin D (F)
  • Dither inhibit input : BNC, 5 V into 2.35 kohm
  • Remote link: 15 way D type (F) – Not used on this model

Configure Your Product

"*" indicates required fields

Contact Sydor For More Information

Name*